The Clip-on Blustooffr. Handsfree VH300 can be connected to any device with Bluetooth wireless technology that supports the handsfrao or headset profile. This User guide focuses on use with a Sony Ericsson mobile phone.
Charging the headset
Before using the VH300 for the /1 you need to charge it with the supplied charger or your phone charger, see figure 3. For compatible charger, see figure 3.
Turning on and off the headset
To turn on the headset
• Press and 00 000 Me on/off key (see figure 2) until the indi.tor light shows a steady green erred light. If the light is red, the headset needs charging. After 3 seconds, the light turns off a. the headset is on.
To turn off the headset
• Press and hold down the on/off key until the Indicator light shows a steady grater red light. If the lIght ,s red, the headset needs charging. After 2 seconds, Me light turns off and the headset taco.
Pairing the headset
Before you can use the headset it h. to be paired once with your phone After a successful pairin9. the headset automatically connects to the phone when it is on a. wiMin range.
To pair the headset with your phone
1. Turn on the Bluetooth function in the phone. For Instructons, .e the phone User guide.
2. Place the phone within 20 cm (8 Inches) of the headset.
3. Press and hold down the on/off key until the ,dcator lIght fl.hes green and red alternately.
4. The first time you tum on the headset it automatically enters pairing mode.
5. Add the headset to your phone as described in your phone User guide. The passcode is 0000.
To pair the headset with another phone
1. Turn off the headset if it is turn. on.
2. Repeat the instructions for how to paw the headset with your phone.
Calling
When you have paired the headset with your phone, you can make and receive calls as long as the headset is tumed on.
Solid objects, walls and a greater distance than 5 metres (16.5 feet) can affect the sound quality negatively.
To make a call
• Use the phone keys to dial the number as normal. The call is automatically activated in the headset.
To coda call
• Press the cal handing key briefly.
To answer a call
• Press the call handling key hr fly
To reject a call (not possible with a second incoming call)
• Press and hold down the call handng key until
you hear a short beep (after 2 seconds).
To radial the last number
• Double-ask the call handing key.
To answer a second call
• Press the at handing key. The ongang call W put on hold.
To switch between two calls
• Press and hold down the call handling key ontrl you hear a beep.
To turn off the microphone (mute)
• Press both co con keys simultaneously. Mute is indicated with a beeping sou.. Repeat to tum on the ncrophone again.
To make a call using voice commands
• Press the cal handling key briefly, wait for a beep and say your command.
Note: Make sure voire commands are enabled and recorded in your phone before you use them.
Transferring sound
To transfer sound from the phone to the headset
• During a call, press the call handling key briefly. The sou. is transferred to the headset.
To transfer sound from the headset to the phone
• See the phone User guide.
Battery
A new, or infrequently used, battery could have reduced capacity. It may need to be recharged a number of times.
When the battery needs charging, the indicator
light flashes red and you hear a low beep. If you
do not charge the headset, it automatically tums off.
To check the battery status
• Press the on oft key briefly:
• one red flash - the battery needs chargIng soon
• two green flashes - the battery 0 half full
• three green flashes - the battery is fully charged
Resetting the headset
To reset the headset
1. Turn off the headset.
2. Press a. hold down the power key until the indi.tor light flash. red and gr.n alternately.
3. Press and hold down the power key and the call handling key simultaneously until the headset turns off.
4. Pair the headset with the phone in the same way as before.
Troubleshooting
The headset is not responding
The capacity of Me battery may be lovv if the headset has not b.n used for a long time. You need to charge the headset several times to get back to the original capacity.
Warning! //you do not plan louse the product for a long time charge the battery until you see three green f.shes. Turn off the product before storing ft.
No comments:
Post a Comment